Wuxi Hongqi Dust Collector Equipment Co.,Ltd.

Structure Characteristics Of Dust Removal in Blast Furnace

Jul 16, 2023 Leave a message

The middle box of the dust collector is a circular cylindrical structure, the design pressure is 0.25MPa, the material is Q345R, and the plate thickness is more than 14mm. Above it:
Check the manhole.
The box is equipped with a nitrogen purge system, which is used to remove the accumulated dust and the cylinder gas displacement purge;
Instrument compressed air system for valve control; Set up artificial dust detection port, convenient sampling and testing.
Suspension housing support. The gas inlet nozzle is provided with a corresponding diversion gas distribution device.
The top of the BF bag dust collector adopts a positive oval head in line with JB/T4746-2002 standard, the wall thickness is more than 16mm, and the material is Q345R. The net gas is connected from the top of the box, and a safety valve and a release pipe are provided on the head.
The lower part of the BF bag dust collector adopts a cone hopper, the material is Q345R, the plate thickness is more than 14mm, and the cone Angle of the cone hopper is 50° to ensure the smooth discharge of dust. Two steam insulation coils are arranged on the lower cone to prevent gas condensation and dust agglomeration which affect ash discharge. The ash level of the ash hopper is detected by a thermal resistance at the upper and lower ash levels, and two sets of bin wall vibrators and nitrogen purge tubes are provided.
The inlet and outlet pipes of the dust collector are respectively equipped with a fully enclosed electric plunger valve, a pneumatic three-eccentric butterfly valve, a large tie rod ripple compensator and a hand hole.